Flare Pants Style – Steps, Conclusion, and More

Introduction

Flare Pants Style, or Bell Boot Pants, are pants adjusted from the hip to the thighs, and from the knee down, it begins to expand a little, forming a little triangle. This type of pants has the particularity of making your body look more stylized.

There are many changes in the shape of flared pants, but the principle of adding flared pants is the same. Whether you’re looking for wide-legged flared pants or burst single boot cut pants, this article will show you how!

Wide leg flare pants for women open outwards from the hip, with a relaxed style.

In this case, the fit is the same as the pants that cross the waist and the top of the hips; we didn’t create a complete pair of pants. The entire waist and high hips fit well. Flare pants began to stretch to the hips, to the hem. These are not flared pants from the 1960s. They extend from the thighs or knees. They are more reminiscent of sailor-style pants.

Make Flare Pants

Step 1. Lift the legs of the pants and seize the bottom seam of each with a straight seam. He sews the right side of the fabric and puts one portion of the pants on the other leg. Match the seams of the pants, then secure the rest of the “U”. Sew with straight stitches along with the “U” shape.

Step 2. Now tighten the belt and fold it down twice. Use straight stitches to sew the entire waistband, but leave a 2-3 inch opening to insert the elastic band. Take a piece of elastic band and place it on the belt.
The easiest way is to place a large safety pin on the end of the elastic band and then use it to pass the belt. Once the elastic band passes through the waistband, firmly sew the two ends of the elastic band together. Tuck your waist toward your waist and close the 2-3-inch opening.

Step 3. It’s time to tie the belt. I didn’t have enough fabric to wear a long tie, so I cut two identical rectangles and sewed them together. Do the short end with the straight stitch and shoot the right side together if you are doing the same operation.

Now fold it in half (combining the right side) and sew along the unfinished edge. Sew a short closed end as well. Then, carefully turn the right side of the cloth tube outward and pull the other end firmly.

Step 4. Now it’s time for the belt buckle. The simplest way to make them is to sew them right away. Take your 3″ x 15″ rectangle and fold it twice on one side and then twice on the other side. Shoot both sides of the folded cloth strip to repair any creases.

Cut the 15-inch strip into five equal pieces, each 3 inches long. Tie both ends under each belt clip, secure it in the desired position on the waistband of the pants and pull back and forth at the top and bottom of the belt clip to hold it in place.